Command Center Reset % Wheel Slip NOTE: Radar or other true ground speed device must be installed and calibrated prior to resetting wheel slip. The procedure will compute and enter the rolling circumference based on radar or other true ground speed device installed on the vehicle. 11:43 AM A It is recommended to have an implement connected to the tractor but not engaged in the ground (no load). RXA0090934 —UN—29SEP06 A Reset % wheel slip value if: Wheel speed and radar speed are not equal when slip is not present Wheel slip is displayed where slip should not be present Tire size was changed + 1.
Reset % slip value by driving tractor on a hard level surface at a constant speed of 8 km/h (5 mph). 2. Press and hold % Slip Switch (A) for a minimum of 3 seconds to zero out slip. RXA0093527 —UN—24APR07 CommandCenter will display: If Calibration is Successful If Calibration is Unsuccessful Calibration Successful Calibration Failed NOTE: Most common reason failed message occurs is because the radar or other true ground speed device is not calibrated properly. See Vehicle Speed Calibration (Automatic) for dual beam radar or Vehicle Speed Calibration (Manual) for single beam radar. Dual Beam Radar Sensor Slip Switch RW29387,00005D2 1902JAN081/1 1616 122208 PN=57