Operator Station Adjusting Active Seat (If Equipped) IMPORTANT: If single lever control is installed on CommandARM™, lever may contact righthand console if seat is placed in full righthand swivel position. Check seat swivel as well as seat height and foreaft adjustment to avoid this contact. RXA0086021 —UN—20JAN06 NOTE: Before operating tractor, adjust Active Seat to your height and weight. This will allow you to get the most from ride zone protection . Active Seat has a builtin buffer at the high and low end of vertical seat travel, resulting in a much smoother ride. Lumbar Support Adjustment Rotate lever (A) to any of five positions.
A—Lumbar Support B—Ride Firmness Control C—Seat Height D—Armrest Angle E—Backrest Angle F—Seat Swivel G—ForeAft Adjustment H—ForeAft Movement Lock Lateral Movement Lock Ride Firmness Control Ride firmness switch (B) provides two different levels of seat suspension performance. Press upper portion of switch for the firmest ride or lower portion for the softest ride. Ride Zone Protection The seat is ride zone protected. The seat will automatically adjust back into the protected zone when operator adjusts the seat height position at or near the vertical seat travel limits. Seat Swivel Lift up on handle (F) to detent position to allow seat to swivel.
Push down on handle to lock seat in position. ForeAft Seat Position Pull up on handle (G) to allow the seat to slide forward or backward. Height Adjustment Turn key switch to ON position. Press lower portion of switch (C) to lower the seat. Press upper portion of switch to raise the seat. Compressor continues to operate until air system is optimized for the given seat height and operator weight. For best seat performance, position seat slightly lower than usual. ForeAft Movement Lock Locks should remain in the UNLOCKED position for maximum performance. Push down on handle (H) to unlock fore and aft suspension. Pull up to prevent foreaft movement.
Armrest Angle Adjustment Turn handle (D) to adjust armrest angle. Lateral Movement Lock Push down on handle (I) to unlock lateral seat suspension. Pull up on handle to lock seat in position. Backrest Angle Pull up handle (E) and adjust backrest to desired angle. CommandARM is a trademark of Deere & Company OURX935,0000473 1912AUG081/1 Using Instructional Seat CAUTION: This instructional seat has been provided only for training operators or diagnosing machine problems. Keep all other riders off the tractor and equipment. Always wear seat belts (A). RXA0062690 —UN—20SEP02 A—Seat Belt OURX935,000042F 1924JAN061/1 252 122208 PN=65