Operator Station Heated Leather Seat (If Equipped) NOTE: Heater will automatically turn off after 1 hour of use and can be turned on again manually, as needed. The heated leather seat provides three heat settings for increased comfort during cold days. Heat intensity is controlled by a momentary switch (A) located in the left armrest. The four settings are: HIGH, MEDIUM, LOW, and OFF. When tractor is shut off, seat heater also turns off or after one hour of use switch will automatically turn off. To start or restart seat heater: Press switch one time for HIGH (Red LED ON). Press switch two times for MEDIUM (Red LED ON). Press switch three times for LOW (Red LED ON).
Press switch four times for OFF (Red LED OFF). RXA0077640 —UN—28SEP04 Heated Leather Seat LED Diagnostics Blink Pattern RXA0077642 —UN—28SEP04 • Red LED On longer than Off—Heating wire failure. Red LED Off longer than On—Temperature sensor failure. Clean seat with mild soap and warm water. Use automotive leather conditioner for conditioning. Conditioning should be done every 6 months if tractor is stored outside. If stored inside conditioning interval can be extended to 12 months. LED momentary switch A—Heated Seat Switch OURX986,00002C8 1918JAN061/1 Adjusting CommandARM Position RXA0085741 —UN—06JAN06 A A—Armrest Control Knob RightHand Side Shown CAUTION:
Be careful when raising or lowering CommandARM console. Fingers could get pinched between mounting plates. 2. Move console/armrest to desired position: Raise console/armrest—Forward and up Lower console/armrest—Rearward and down 1. Support console and loosen knob (A). 3. Tighten knob (A). OURX935,0000401 1902JAN081/1 253 122208 PN=66