Isuzu — 16BBG_Sec01_Introduction revision 6 082316 final

2016 Isuzu Truck INTERFERENCE CAUSING EQUIPMENT STANDARD – ICES-002 Applies to all models of incomplete vehicles except vehicles equipped with diesel engines contained in this book TYPE 1 The following statement is applicable to all models of incomplete vehicles except vehicles equipped with diesel engines (unless otherwise noted on the cover of this document). This incomplete vehicle, when completed, will conform to the above regulations providing no alterations are made which affect the function, physical, chemical, or mechanical properties, environment, location or vital spatial clearances of the components, assemblies or systems including but not limited to those listed below:

Ignition wires & plugs Spark plug wires Ignition coil(s) PART 2 U.S. ENVIRONMENTAL PROTECTION AGENCY AND STATE OF CALIFORNIA EMISSION REQUIREMENTS AND ON-BOARD DIAGNOSTIC SYSTEM (OBDII/HD-OBD/EMD) REQUIREMENTS To assure that EPA and California emission certificate requirements and OBDII/HD-OBD/EMD requirements are met, this incomplete vehicle (except where noted) must be completed in strict accordance with all instructions contained in this document, especially the following instructions which relate to: A. Exhaust emission related components B. Specification for fill pipes and openings of motor vehicle fuel tanks (applicable only to California gasoline powered vehicles) C.

Labels (A) EXHAUST EMISSION RELATED COMPONENTS 1. Compliance of this vehicle with EPA/California emission certification requirements and OBDII/HD-OBD/EMD requirements will be maintained providing no alterations (except where noted) are made to the components identified below:

Air Inlet System Exhaust Gas Temperature Sensor Boost Pressure Sensor Exhaust Oxygen Sensors (if equipped) Catalytic Converter, its Location and Related Sensors Exhaust System Charge Air Cooler and Related System Fuel Injection Components/Controls Crank Case Emission Control System Fuel System Diesel Exhaust Fluid (DEF) Injector Ignition System (Gasoline Engine) Diesel Exhaust Fluid (DEF) Plumbing and Wiring Injection Pump Diesel Exhaust Fluid (DEF) Pump, Diesel Exhaust Fluid (DEF) Tank Injector and High Pressure Lines Diesel Particulate Filter (DPF), its Location and Related Sensors Intake Manifold Engine Assembly Intake Manifold Temperature Sensor Engine Coolant Temperature Sensor MAF Sensor Engine Electronics (ECM, PCM, VCM) NOX Sensors Engine Speed Sensor Selective Catalytic Reduction (SCR) System, its Locations and Related Sensors Exhaust Emission Control System Transmission Control Module (TCM Exhaust Gas Recirculation System and Related Sensors Turbo Charger and Associated Equipment/Controls VNT Compressor Out Air Temperature Sensor * Evaporative Emission Control System (if equipped) * All Federal/California gasoline powered heavy duty vehicles will have an evaporative emission control system that is certified for a fuel tank capacity not to exceed the amount shown on Vehicle Evapo­ rative Emission Control Information Label.

Persons wishing to add fuel tank capacity above the amount shown must contact California Air Resources Board and/or submit a written statement to the EPA Administrator that the Hydrocarbon Storage System has been upgraded according to the requirements of 40 CFR 86-095-35 (g) (2). PAGE 1.6