112 Maintenance Section Engine Oil Level - Check 9. Close the engine access door. i01562646 Engine Oil Level - Check SMCS Code: 1000-535-FLV NOTICE Do not under fill or overfill engine crankcase with oil. Either condition can cause engine damage. NOTICE Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, test- ing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before open- ing any compartment or disassembling any compo- nent containing fluids.
g00811500 Illustration 176 Refer to Special Publication, NENG2500, “Caterpillar Tools and Shop Products Guide” for tools and supplies suitable to collect and contain fluids on Caterpillar products. 2. Remove oil supply tube (3) from the governor. 3. Remove fitting (1) and seal (2) from the governor housing. Dispose of all fluids according to local regulations and mandates. g00811528 Illustration 177 4. Use a 6 mm hexagon wrench to remove screen (4). 5. Wash the screen in a clean, nonflammable solvent. Inspect the screen and the seal for damage. Replace the screen and/or the seal, if necessary. g00811672 Illustration 178 6.
Install the screen far enough into the governor housing in order to allow clearance for the seal and for the fitting. 1. Open the engine access door on the right rear side of the machine. The engine oil dipstick (1) is located on the left side of the engine. 7. Install seal (3), fitting (2), and oil supply tube (1). 2. Remove engine oil dipstick (1) and wipe the dipstick with a clean cloth. Then, insert the dipstick and remove the dipstick again. This will ensure a more accurate measurement of the engine oil level. 8. Start the engine and check the engine governor for leaks. Stop the engine and make any necessary repairs.