Basic components turning on the main switch to make sure all segments come on. power trim and tilt switch. NOTE: The speedometer displays km/h, mph, or knots, according to operator preference. Se- lect the desired unit of measurement by set- ting the selector switch on the back of the gauge. See the illustration for settings. EMU26620 Trim meter (digital type) This meter shows the trim angle of your out- board motor. NOTE: G Memorize the trim angles that work best for your boat under different conditions. Adjust the trim angle to the desired using the power trim and tilt switch.
G If the trim angle of your motor exceeds the trim operating range, the top segment on the trim meter display will blink. 1. Cap 2. Selector switch (for speed unit) 3. Selector switch (for fuel sensor) EMU26610 Trim meter This gauge shows the trim angle of your out- board motor. EMU26650 Hour meter (digital type) This meter shows the number of hours the engine has been run. It can be set to show the total number of hours or the number of hours for the current trip. The display can also be turned on and off. ZMU01869 ZMU04581 NOTE: Memorize the trim angles that work best for your boat under different conditions. Adjust the trim angle to the desired setting with the ZMU01870 19