Basic components G Changing the display format G Pressing the “ ” (mode) button chang- es the display format in the following pat- tern: EMU26700 Clock Press the “ ” (mode) button repeatedly until the indicator on the face of the gauge points to “ ” (time). To set the clock, be sure the gauge is in the “ ” (time) mode. Press the “ ” (set) button; the hour display will begin blinking. Press the “ ” (mode) button until the desired hour is displayed. Press the “ ” (set) button again, the minute display will begin blinking. Press the “ (mode) button until the desired minute is dis- played. Press the “ ” (set) button again to start the clock.
G Total hours Trip hours Display off G Simultaneously pressing the “ ” (set) and “ ” (mode) buttons for more than 1 second while the trip hours are displayed resets the trip counter to 0 (zero). NOTE: The total number of hours the engine has been run cannot be reset. G Resetting the trip hours EMU26690 Trip meter This gauge displays the distance the boat has traveled since the gauge was last reset. Press the “ ” (mode) button repeatedly until the indicator on the face of the gauge points to “ ” (trip). To reset the trip meter to zero, press the “ ” (set) and “ (mode) buttons at the same time. NOTE: The clock operates on battery power. Dis- connecting the battery will stop the clock.
Reset the clock after connecting the battery. EMU26710 Fuel gauge The fuel level is indicated by eight segments. When all segments are showing, the fuel tank is full. NOTE: G The trip distance is shown in kilometers or miles depending upon the unit of measure- ment selected for the speedometer. ECM00860 CAUTION: The Yamaha fuel tank sensor differs from conventional sensors. Incorrectly setting the selector switch on the gauge will give false readings. Consult your Yamaha dealer on how to correctly set the selec- G The trip distance is kept in memory by bat- tery power. The stored data will be lost if the battery is disconnected. 20