IMPORTANT INFORMATION EB101030 LOCK WASHERS/PLATES AND COTTER PINS 1.Replace all lock washers/plates 1 and cotter pins after removal. Bend lock tabs along the bolt or nut flats after the bolt or nut has been tightened to specification. EB101040 BEARINGS AND OIL SEALS 1.Install bearings and oil seals so that the manufacturer’s marks or numbers are visible. When installing oil seals, apply a light coat- ing of lightweight lithium base grease to the seal lips. Oil bearings liberally when install- ing, if appropriate. 1 Oil seal CAUTION: Do not use compressed air to spin the bearings dry. This will damage the bearing surfaces.
1 Bearing EB101050 CIRCLIPS 1.Check all circlips carefully before reassem- bly. Always replace piston pin clips after one use. Replace distorted circlips. When install- ing a circlip 1 , make sure that the sharp- edged corner 2 is positioned opposite the thrust 3 it receives. See sectional view. 4 Shaft 1 - 11 GEN INFO