CHECKING OF CONNECTIONS EB801000 CHECKING OF CONNECTIONS Check the connectors for stains, rust, mois- ture, etc. 1.Disconnect: Connector 2.Check: Connector Moisture Dry each terminal with an air blower. Stains/rust Connect and disconnect the terminals several times. 3.Check: Connector leads Looseness Bend up the pin 1 and con- nect the terminals. 4.Connect: Connector terminals NOTE: The two terminals “click” together. 5.Check: Continuity (using a pocket tester) NOTE: If there is no continuity, clean the terminals. When checking the wire harness be sure to perform steps 1 to 3. As a quick remedy, use a contact revitalizer available at most part stores.
Check the connector with a pocket tester as shown. 1 - 12 GEN INFO