OPERATION MACHINE OPERATIONS AND CONTROLS Depth Display (Depth From Ground Surface) 0. When the engine is started and the switch is ON, the depth dis- play will always indicate the depth from the ground surface unless depth display 0 set mode is being used. If work equipment is above ground level, UP is displayed. REMARK This display assumes that the bucket is pointing down, so if the bucket is in the condition shown in the diagram on the right, the actual depth may be different from the dis- play depth. When measuring the depth, always set the machine hori- zontally. Setting Depth Display 0 Set Mode (Depth From Standard Surface) 0.
This displays the desired standard surface as 0.0 m (0.0 in), and displays the depth of the bucket from this surface. 1. Turn mode selector switch (1) to the depth display 0 set mode position. 2. Set the machine horizontally, and align the bucket with the position to use as the standard surface. When aligning, the way in which the bucket is placed becomes the standard for the depth display. 3-77