„ NOTE: Turn the key switch to the OFF position then back to the ON position to reset the malfunction code. If the code continues to be dis- played, take your Prowler to an autho- rized Arctic Cat Dealer for EPS system servicing before resuming operation. „ NOTE: Approximately two seconds after releasing either Button, the LCD will return to normal operation. „ NOTE: Clock memory power is supplied through the 15-amp acces- sory fuse and verified during gauge “power-up” and reset. In the event of clock memory power failure (blown fuse, etc.), the gauge will “power-up,” reset, and shut down repeatedly until clock memory power is restored.
Always check the 15-amp accessory fuse if this gauge condition is noted. CAUTION Never operate this vehicle with a “P0635” code indicated on the LCD gauge/speedometer. This indicates a malfunction in the EPS system con- trol circuit and could result in a loss of power steering assist. „ NOTE: The engine hour meter will not activate until engine speed exceeds 500 RPM. In the event of electrical power failure, the EPS system becomes disabled (simi- lar to an automobile with the engine shut off). Steering effort increases but steering control can be maintained. 2. Fuel Level Indicator - Indicates approximate amount of gasoline in the gas tank. LCD Gauge (XTZ) 1.
Clock/Hour Meter - The clock func- tion indicates time in the 12 hour mode; the hour meter indicates the total time the vehicle has run and cannot be reset to zero. „ NOTE: When the bottom segment flashes, approximately 3.8 L (1.0 U.S. gal.) of gasoline remains in the tank. 3. Mode Button - Shifts the digital gauge through three modes: speed/ tachometer, distance, and time. DIVISION II - OPERATION/ MAINTENANCE „ NOTE: The Mode Button must be pressed and released to shift modes. Approximately two seconds after the Mode Button is released, the digital gauge will return to full display. 4.
Set/Reset Button - In conjunction with the Mode Button, sets and resets various displays on the digital gauge. Also used to switch from speedome- ter function to tachometer function on the speedometer/tachometer gauge. CF094F A. With the ignition switch ON, press and release the Mode Button (3) until the Clock/Engine Hour Meter (1) is displayed; then (if necessary) press and release the Set/Reset Button (4) to the clock display. 5. Odometer/Trip Meter (#1 and #2) - Odometer registers the total distance the vehicle has traveled. Trip meters can register two distances (for instance, #1 could register trip dis- tance and #2 could register distance between stops).
The trip meters can be reset while the odometer only reg- isters accumulated miles/kilometers. B. Press and hold the Set/Reset But- ton (4) until the minutes stop scrolling and the hour display starts to scroll. Momentarily release when the correct hour is displayed; then repeatedly press and release the Set/Reset Button (4) until the correct minutes are displayed. 29