„ NOTE: To select the odometer (ODO), trip #1 (T1), or trip #2 (T2), press the Mode Button (3) to select the distance mode; then press the Set/Reset Button (4) to select the desired display. Hold the Set/Reset button down to reset trip meters. 6. Gear Position Indicator - Indicates which gear is selected. 7. Speed/Tach Indicator - Indicates approximate vehicle speed in mph or k/ph when speedometer function is selected or rpm when tachometer function is selected. FI001B Battery Condition Indicator - The word VOLT will flash on the LCD whenever a low voltage ( age (>16 DC volts) is detected. 8.
Speed Function Display - Displays which speed function (MPH, TACH, K/PH) is being indicated by the Speed/Tach indicator. Temperature Indicator - The high temper- ature icon will flash and the speed/tach needle will sweep full scale if the engine overheats. After 30 seconds, the speed/ tach needle will return to normal, but the temperature icon will continue to flash. The icon should not be visible during normal operation. „ NOTE: The speed and tach func- tions may be switched by pressing the Set/Reset Button. 9. Differential Lock Indicator - Displays LOCK when the differential lock has been engaged. CAUTION 10.
Drive Select Indicator - Displays 4WD when selected by the drive select switch or when the differential lock is engaged. Continued operation with high engine temperature may result in engine damage or premature wear. „ NOTE: High engine RPM, low vehi- cle speed, or heavy load can raise engine temperature. Decreasing engine RPM, reducing load, and selecting an appropriate transmis- sion gear can lower the temperature. 11. High Beam Indicator - The High Beam icon will appear only when the lights are on high beam. 12.
EFI Malfunction Indicator - The speedometer/tachometer needle will sweep full scale and the LCD will go blank except a malfunction code and wrench icon will be displayed on the LCD whenever an electronic fuel injection malfunction code is detected. After 30 seconds, the LCD and speedometer/tachometer will return to normal, but the malfunc- tion code and wrench icon will con- tinue to be displayed on the LCD until the malfunction is corrected. „ NOTE: Debris in the engine com- partment (or packed between the cooling fins of the radiator) can reduce cooling capacity. Using a garden hose, wash the radiator and the engine to remove any debris preventing air flow.
CAUTION Arctic Cat does not recommend using a pressure washer to clean the radiator core. The pressure may bend or flatten the fins causing restricted air flow, and electrical components on the radiator could be damaged. Use only a garden hose with spray nozzle at normal tap pressure. „ NOTE: Take the vehicle to an authorized Arctic Cat dealer to have the error corrected and the system error reset as soon as possible. 30