LCD Gauge (XT/XTX) „ NOTE: All segments of the LCD will activate for approximately two seconds when the ignition switch is rotated to the ON position. 2. Temperature Indicator - If the engine coolant temperature exceeds the nor- mal operating range, the temperature icon will begin flashing and the LCD will go blank for 30 seconds; then the LCD will return to normal. However, the temperature icon will continue to flash. CAUTION Continued operation with high engine temperature may result in engine damage or premature wear. „ NOTE: High engine RPM, low vehi- cle speed, or heavy load can raise engine temperature.
Decreasing engine RPM, reducing load, and selecting an appropriate transmis- sion gear can lower the temperature. HDX192A 1. Clock/Engine Hour Meter - The clock function indicates time in the 12-hour mode; the hour meter indicates the total time the engine has run and can- not be reset to zero. To set the clock, use the following procedure. „ NOTE: Debris in front of the engine (or packed between the A. With the ignition switch ON, press and release the Mode But- ton (3) until the Clock/Engine Hour Meter (1) is displayed; then (if necessary) press and release the Set/Reset Button (4) to select the clock display. B.
Press and hold the Set/Reset But- ton (4) until the minutes stop scrolling and the hour display starts to scroll. Momentarily release when the correct hour is displayed; then repeatedly press and release the Set/Reset Button (4) until the correct minutes are displayed. 3. Mode Button - Shifts the gauge through three set-up modes: speedom- eter/tachometer, distance, and time. „ NOTE: Clock memory power is supplied through the 15-amp acces- sory fuse and verified during gauge “power-up” and reset. In the event of clock memory power failure (blown fuse, etc.), the gauge will “power-up,” reset, and shut down repeatedly until clock memory power is restored.
Always check the 15-amp accessory fuse if this gauge condition is noted. „ NOTE: The Mode Button must be pressed and released to shift modes. Approximately two seconds after the Mode Button is released, the digital gauge will return to full display. 4. Set/Reset Button - In conjunction with the Mode Button, sets and resets various displays on the digital gauge. Also used to shift from speedometer function to tachometer function on the speedometer/tachometer gauge. „ NOTE: The engine hour meter will not activate until engine speed exceeds 500 RPM. 31 reduce cooling capacity. Using a garden hose, wash the radiator and the engine to remove any debris restricting air flow.
DIVISION II - OPERATION/ MAINTENANCE CAUTION Arctic Cat does not recommend using a pressure washer to clean the radiator core. The pressure may bend or flatten the fins causing restricted air flow, and electrical components on the radiator could be damaged. Use only a garden hose with spray nozzle at normal tap pressure.