Section 0 - Engine Disassembly and Assembly - Group 00 Engine Assembly (0-02) M11 Page 0-115 Push the number four support toward the rear of the engine and tighten the support capscrew. Torque Value: 122 [90 ft-lb] Install a 0.55 mm [0.022 inch] feeler gauge between the number four support and the intake lever for the number three cylinder. Push the number three support toward the rear of the engine and tighten the support capscrew. Torque Value: 122 [90 ft-lb] Install a 0.55 mm [0.022 inch] feeler gauge between the number three support and the exhaust lever for the num- ber two cylinder. Push the number two support toward the rear of the engine and tighten the support capscrew.
Torque Value: 122 [90 ft-lb] Install a 0.55 mm [0.022 inch] feeler gauge between the number two support and the intake lever for the number one cylinder. Push the number one support toward the rear of the engine and tighten the support capscrew. Torque Value: 122 [90 ft-lb] Check the front and rear assemblies for correct clear- ance. Check the support capscrews for the correct torque value.