Engine Assembly (0-02) Section 0 - Engine Disassembly and Assembly - Group 00 M11 Page 0-130 Spread the lubricant across the connector nose piece so it enters every pin hole and lubricates the contacts. Lu- bricant must not be visible on the surface of the nose piece. Install the actuator wiring harness connector to the upper plug nearest the engine on the ECM. Install the sensor wiring harness connector to the lower plug on the ECM. Tighten the connector capscrews. Torque Value: 2.0 [18 in-lb] Use two wire clamps and two capscrews (M6-1.00 x 16) to fasten the actuator harness to the bracket at point (1) and the sensor harness to the bracket at point (2).
Fuel Filter Head and Bracket - Installation Different engine applications can have the fuel filter bracket and filter head mounted at different locations on the engine. Some engines have a pump mounted filter head. Install the bracket and filter head in the same lo- cation it was removed from. Use four capscrews (M10-1.50 x 25) to install the filter head to the engine. Torque Value: 47 [35 ft-lb] Fuel Pump Plumbing - Installation Install the fuel lines: fuel drain from T-block connection (1), fuel pump supply (2), fuel supply to injectors (3). Install the correct actuator harness wire connector to the fuel shutoff valve.