Section 16 - Mounting Adaptations - Group 16 Rear Engine Power Takeoff (REPTO) - Rebuilding (16-05) M11 Page 16-15 If the rolling resistance is not within the specifications, remove the output flange and smaller bearing. Add or subtract shims to obtain the correct rolling resis- tance. NOTE: Adding more shims will decrease the resistance, and removing shims will increase resistance. Any combination of shims can be used. Once the correct rolling resistance is obtained, remove the output flange and install a new oil seal. Press the oil seal flush with the housing surface. Apply pipe sealant, Part No. 3375066, to the output flange capscrew and under the washer.
Install the output flange flat washer and capscrew. Torque the capscrew. Torque Value: 205 [150 ft-lb] Install a new o-ring on the bearing housing cover. Use clean vegetable oil to lubricate the o-ring.