Engine Assembly (0-02) Section 0 - Engine Disassembly and Assembly - Group 00 M11 Page 0-74 If the TIR still exceeds the specification, the flywheel must be replaced. Flywheel Face Runout - Measurement Install the contact tip of the indicator against the flywheel face as close as possible to the outside diameter to mea- sure the face (4) runout. Push the flywheel forward to remove the crankshaft end thrust. Rotate the crankshaft one complete revolution (360 de- grees) while keeping the crankshaft end thrust pushed forward. The maximum TIR must not exceed the following speci- fications.
Flywheel Face Runout Radius (A) Maximum TIR mm in mm in 203 8 0.203 0.008 254 10 0.254 0.010 305 12 0.305 0.012 356 14 0.356 0.014 406 16 0.406 0.016 If the face runout does not meet these specifications, the flywheel must be replaced.