Crankshaft, Main Bearings and Flywheel/Oil seal/wear sleeve installation CTM3274 (01JUL99) 15-17 Saran Liter Engines 060799 PN=114 OIL SEAL/WEAR SLEEVE INSTALLATION NOTE: Due to a diameter change of the crankshaft bore, it may be necessary to suppress the pilot pin (A) from KCD10002 tool. With this modification KCD10002 becomes KCD10002A. -UN-16JUN98 1. Apply a light coating of sealant compound (Loctite 609 or equivalent) on crankshaft end. CD30586 2. Position the guide plate (A) from KCD10002A tool set over dowel with two cap screws. Finger tighten both cap screws until they contact the pilot. 3.
Using the oil seal/wear sleeve assembly with open side toward engine, center the guide plate and tighten the two cap screws. 4. Slide driver (B) onto guide and gradually tighten nut -UN-18JAN95 until driver bottoms. CD7142 -UN-18JAN95 CD7143 CD,3274,G15,14 -19-04JAN99 15 17