10 Fieldwork settings 10.6 Crop receptacle / straw receptacle 67086 Move the straw chopper to the rear as far as pos- sible, using crank (14). 12 Danger! Pinch point from moving machine parts. Serious injuries. 14 Secure machine parts. Comply with instructions. Bolt down turn lock (12), thus securing the straw chopper against sliding to the front. 28801 37 The sieves can now be installed. When installation of sieves is complete, the straw chopper must be moved back to its initial position at the front (putting the straw chopper out of operation). 20 B A Move the straw chopper fully to the front, using the crank. Use lever (17) for lifting support (16) over the keeper (18).
Unlock panel (20) and fold it down. Connect speed monitoring cable at position (B). Fit connecting rod at position (A). 28800 38 16 18 17 39 12 13 5 28710 Install belt (5) and bolt down guard (19). Bolt down turn locks (12) on both sides. Tighten the turn lock (13). Check belt (5). The belt (5) must make contact with all pulleys, jockey pulleys and guide rollers. Provide contact of belt if required. Close the right side cover. 12 19 40 28748 190 00 0293 210 2 - BA DOMINATOR 150/140/130 - 12/09