5 Prior to initial operation 5.2 Chassis 67081 WARNING: The tyres may collide with the vehicle body. Damage to tyres and vehicle body. Adjust track width to the tyres used. Adjust the rear axle position of the central axle pivot pin with the axle. See table of rear axle positions Danger! Jacking up the machine. Death or serious injury. Use jack / jack stand with sufficient capacity. Use reliable jack / jack stand. Use jack / jack stand on solid and level ground. Apply the jack / jack stand at the position of the machine intended for this purpose.
Suspend the machine in the lift eyes at the rear and lift it (see loading and tying down the machine) until the rear axle wheels have only slight ground contact. Securely underpin axle against lowering and tip- ping over. Unscrew flat bar (2) and pull out pin (1). Raise or lower machine. Insert pin (1) into the bottom or top hole and bolt down flat bar (2). For rear axle rise (rice) see rice threshing equipment. 2 1 4 27234 If necessary, adjust rear wheel drive axle 00 0649 950 1 wheel track. 79261 5.2.4 Rear axle 00 0649 950 1 – Adjusting the track width Observe the general warnings at the beginning of the Prior to initial operation chapter. Warning:
The tyres may collide with the vehicle body. Damage to tyres and vehicle body. Adjust track width to the tyres used. The track width depends on the flange width (F) to be set and on the tyres. The axle can be set to three different flange widths. 00 0293 210 2 - BA DOMINATOR 150/140/130 - 12/09 91