5 Prior to initial operation 5.2 Chassis 67081 1 Danger! Jacking up the machine. Death or serious injury. 3 Use jack / jack stand with sufficient capacity. Use reliable jack / jack stand. Use jack / jack stand on solid and level ground. Apply the jack / jack stand at the position of the machine intended for this purpose. 2 19471 5 Jack up the machine a little at the rear until the rear axle wheels only have slight ground contact. Remove the right-hand ball joint of the track rod. Remove steering cylinder mounting bracket (1) from the axle body. Slacken off the clamping bolts (2) on both sides. Unscrew mounting bolts (3) on both sides.
Slide the adjustable axle sections in or out to obtain the desired track width (2300 mm, 2500 mm, 2700 mm). Install mounting bolts (3), but do not tighten them at this time. Tighten clamping bolts (2) first, then tighten mounting bolts (3). Bolt down mounting bracket (1) in the correspond- ing tapped holes. Set the wheels to zero toe-in by adjusting the right-hand ball joint on the track rod. In order to obtain accurate measurements, measure from the inside edges of the rim, where the beading of the tyres rests. Secure the track rod. Use new self- locking nuts. Tightening torque = 140 Nm 92 00 0293 210 2 - BA DOMINATOR 150/140/130 - 12/09