MAINTENANCE Engine Oil and Filter Service NOTE: The sealing surface on the drain plug should be clean and free of burrs, nicks or scratches. Always change engine oil and filter at the intervals outlined in the Periodic Maintenance Chart. Always change the oil filter whenever changing the engine oil. 8. Reinstall drain plug and torque to 16 ft. lbs. (22 Nm) . 9. Remove both seats and rear service panel. WARNING 10. Place shop towels beneath oil filter. Using Oil Filter Wrench (PV-43527) and a 3/8” extension, turn the oil filter counter-clockwise to remove it. 2 Personal injury can occur when handling used oil. Hot oil can cause burns or skin damage. Oil Filter Recommended Engine Oil:
Premium 4-Cycle Synthetic OW-40 (PN 2871281) (Quart) Ambient Temperature Range -40° F to 120° F 1. Position vehicle on a level surface. 11. Using a clean dry cloth, clean filter sealing surface on the crankcase. 2. Place the transmission in PARK (P). 3. Start the engine. Allow it to idle for two to three minutes until warm. Stop the engine. 12. Lubricate O-ring on new filter with a film of fresh engine oil. Check to make sure the O-ring is in good condition. 4. Clean area around oil drain plug at bottom of engine. 13. Install new filter and turn by hand until filter gasket contacts the sealing surface, then turn an additional 1/2 turn. 14.
Remove dipstick and fill sump with 2 quarts (1.9 l) of Polaris Premium 4-Cycle Synthetic Oil (PN 2871281). Crankcase Drain Plug Torque: 16 ft. lbs. (22 Nm) NOTE: Drain plug is accessed through the skid plate. Drain Plug Oil Filter Torque: Turn by hand until filter gasket contacts sealing surface, then turn an additional 1/2 turn Oil Filter Wrench: (PV-43527) CAUTION 15. Verify the transmission is still positioned in PARK (P). Oil may be hot. Do not allow hot oil to come into contact with skin, as serious burns may result. 16. Start the engine and let it idle for one to two minutes. 17. Stop the engine and inspect for leaks. 5.
Place a drain pan beneath engine crankcase and remove the drain plug. 18. Re-check the oil level on the dipstick and add oil as necessary to bring the level to the upper mark on the dipstick. 6. Allow oil to drain completely. 7. Replace the sealing washer on drain plug. 19. Dispose of used oil and oil filter properly. 2.15