Removal and installation of engine 01.8 352/352 A 3 Locate and tighten fastening bolts of rear en- gine rtlOunts. See 1.4/1 for tightening torque. 4 Lower engine and remove special tool No. 19. Attach engine breather filter with sealant No. 2. 5 Remove starter wiring loom and venting line from clutch housing. Also remove fuel line, leak-off line, cold start line and idling control cable as fitted to special version 35 989. Adjust idling setting, see 30.4·2.1/1. 6 Attach clutch slave cylinder after coating seal- ing surface with seal ant No. 2. 7 Attach propeller shaft to input flange. UKD 30 402 21 42-01 2.117