26. HANDLING PAYLOAD METER METHOD OF CUTTING PRINTER PAPER 1. Press the FEED switch to feed the paper out to the necessary position. 2. Put the paper in contact with the cutter on the lid, then pull up to cut the paper from one side to the other. Do not pull the paper out and cut it without using the paper cutter. AE134800 STORING PRINTER PAPER The printer paper is thermal paper, so store it in a place where the temperature range is between 0°C and 40°C. Do not keep it in a place exposed to direct sun light. IF ERROR MESSAGE E-33 IS DISPLAYED When the starting switch key is turned to the OFF position, the payload meter uses the internal battery to prevent the load data from being deleted.
If the battery voltage drops, error message E-33 is displayed, so replace the battery as follows. Replacing battery Move the machine to a place where it is safe to carry out the replacement operation. Parts to prepare Crosshead screwdriver Socket wrench (for M4 nut) New battery (7818-27-2860) 1. Turn the starting switch key to the ON position, press the PRINT switch for at least 2 seconds, and print out the load data from memory. Do not start the engine when doing this. 2. Turn the starting switch back to the OFF position. 5-10