TM2361 (24JUN08) 9015-15-32 450DLC Excavator Operation and Tests 062608 PN=476 Sub-System Diagnostics MCF inputs involved: • Travel Alarm Control • Reversing fan switch (S15) Work Mode Control: The work modes are selected on • Engine speed dial (R15) the monitor controller and are communicated through • Pilot shutoff switch (S3) the CAN data link to the MCF. The MCF can adjust • A/C controller (A7) (blower relay control) pump flow rate delivery and engine speed depending on the work mode or attachment selected. Pump flow MCF outputs involved: and engine speeds can be adjusted with the monitor controller or by using Dr. ZX.
• Fan pump control solenoid (Y14) • Reversing fan solenoid (Y8) (and Y9; 850DLC only) Engine Oil Level Check Control: This function checks • ECM (through CAN) fluid levels and displays the results on the monitor controller when circuit is enabled. Pushing reversing fan switch (S15) to the ON position provides a ground to terminal B12 on the MCF. When MCF inputs involved:
the MCF detects this ground, and if the pilot shutoff lever is at the rearward (LOCK) position and the air • Engine fluid level check switch (S21) conditioning is OFF, the MCF sends a signal to the • Coolant level switch (B13) ECM (through the CAN data link) to reduce engine • Engine oil level switch (B15) speed—assuming the engine speed is more than slow idle. This takes approximately 20 seconds. MCF outputs involved: Level indicators on monitor 9015 15 32 controller (through CAN) The MCF also reduces the cooling fan speed by increasing current to fan pump control solenoid (Y14).
Pushing engine fluid level check switch (S21) to the When the engine speed and fan speed have ON position provides a ground to terminal C20 on the decreased to an acceptable level, the MCF will send MCF. When the MCF detects this ground, the MCF will current out terminals A29 and A32 to energize monitor signals from coolant level switch (B13) reversing fan solenoid (Y8) (and Y9; 850DLC only). (terminal C21) and engine oil level switch (B15) With the reversing fan solenoid energized, oil is (terminal C9). rerouted through the fan motor causing it to run in reverse.
The MCF then increases the fan speed to When the contacts of a level switch are open, the MCF maximum (in reverse) to blow dust and debris from the sends a signal to the monitor controller (through the radiator/oil cooler/intercooler. CAN data link), causing the corresponding level indicator to display green. After approximately 60 seconds of running the fan at maximum speed, the MCF decreases the fan speed When the contacts of a level switch are closed, the and de-energizes the reversing fan solenoid (Y8) (and MCF sends a signal to the monitor controller (through Y9; 850DLC only).
The MCF then resumes normal fan the CAN data link), causing the corresponding level operation and engine speed as before. indicator to display red. Miscellaneous Controls—The miscellaneous controls Travel Alarm Control: When in travel operation, the involve the following functions: main controller activates travel alarm (H4). For additional information, see Travel Alarm Circuit Theory • Work Mode Control of Operation. (Group 9015-15.) • Engine Oil Level Check Control CS33148,00008EB –19–28APR06–15/15