John Deere 450DLC — Component Checks

TM2361 (24JUN08) 9015-20-101 450DLC Excavator Operation and Tests 062608 PN=591 References Battery Relay Check See Machine Harness (W2) Component Location. (Group 9015-10.) Disconnect harness from relay. Connect 24 volts to small terminal S and ground small terminal E. LISTEN: Does the relay click? T8182AK –UN–03MAR94 Connect the multimeter to large terminals A and B. LOOK: Is continuity measured? YES: Relay is OK. Check the wiring harness. See Machine Harness (W2) wiring Diagram. (Group 9015-10.) NO: Relay has failed. Replace the relay.

– – –1/1 Battery Voltage Check Measure battery voltage by connecting a multimeter to (-) negative battery terminal grounded to frame and (+) positive battery terminal connected to machine harness. LOOK: Are 24 to 28 volts measured? T7487AF –UN–20MAR91 YES: Batteries are OK. NO: Batteries are undercharged. Charge batteries. See Using a Battery Charger. (Operator’s Manual.) – – –1/1 9015 20 ,101 Fusible Link Check Press locking tab on side of fusible link and lift from holder. Connect a multimeter to female terminals inside fusible link. LOOK: Does the multimeter read continuity? T8182AN –19–03MAR94 YES: Fusible link is OK. Check the wiring harness. See Machine Harness (W2) Wiring Diagram.

(Group 9015-10.) NO: Fusible link has failed. Replace the fusible link. See Fuse and Relay Specifications. (Group 9015-10.) – – –1/1