All Hydraulic Functions Slow Diagnostic Procedure NOTE: Reduction in pump 1 and 2 flow rate due to other reasons or faulty pilot system may cause this problem. If unloaded function speed is satisfactory, diagnose low power problem, see All Hydraulic Functions Low Power Diagnostic Procedure. (Group 9025-15.). –1/1 TM2361 (24JUN08) 9025-15-3 450DLC Excavator Operation and Tests 062608 PN=753 Diagnostic Information 8 Wiring Connector Check See System Functional Schematic, Wiring Diagram, and Component Location Master Legend. (Group 9015-10.) Inspect hydraulic control wiring. NOTE: Most wiring problems should generate a DTC, check for DTC’s before tracing wiring.
Are all the connectors in good condition? YES: Replace monitor unit. See Monitor Controller Remove and Install. (Group 9015-20.) NO: Repair or replace connectors. – – –1/1 Diagnose All Hydraulics Slow Malfunctions IMPORTANT: Make sure hydraulic oil level, condition, and type of oil is checked before doing this procedure. • Hydraulic oil temperature, cold oil can slow hydraulic functions. • Low oil level can cause pump cavitation, see Check Hydraulic Tank Oil Level. (Operator’s Manual.) • Suction side air leaks will cause oil to foam or become aerated. Inspect site glass oil condition. • Wrong viscosity oil can cause pump cavitation, see Hydraulic Oil.
(Operator’s Manual.) TX19495,0000004 –19–26APR06–1/1 9025 15 3