TM2361 (24JUN08) 9025-15-19 450DLC Excavator Operation and Tests 062608 PN=769 Diagnostic Information 3 Circuit Relief Valve Check Key on, use monitor service menu to display Pump 1 or Pump 2 Delivery Pressure. See Monitor Service Menu Operation. (Group 9015-16.) Put power mode switch on HP and work mode on digging. Run engine at fast idle and operate each digging function over relief. Record pressure. Do all circuit relief valve above 30.4 MPa? YES: Go to Control Valve Spool Check. NO: Adjust or repair circuit relief. Perform Circuit Relief Valve Test and Adjustment. (Group 9025-25.) – – –1/1 4 Control Valve Spool Check Inspect control valve spool for sticking or contamination.
See Control Valve 5-Spool Disassemble and Assemble. (Group 3360.) Does control valve spool move freely? YES: Go to Cylinder Drift Check NO: Clean and repair valve spool. See Control Valve Disassemble and Assemble. (Group 3360.) – – –1/1 5 Cylinder Drift Check Perform Cylinder Drift Test—Boom, Arm, and Bucket. (Group 9025-25.) Do cylinders pass drift test? YES: Diagnostic procedure completed. NO: Repair cylinder seals. – – –1/1 9025 15 19 Arm Or Bucket Speeds Are Slow During Combined Function With Boom Lower Diagnostic Procedure – – –1/1