John Deere 450DLC — Boom Flow Rate (port SF) Test and Adjustment

TM2361 (24JUN08) 9025-25-31 450DLC Excavator Operation and Tests 062608 PN=891 Tests 9. Adjust the solenoid valve (H) as needed. a. Loosen nut (J). IMPORTANT: Turning adjusting screw out too far may cause oil leakage because the O-ring –UN–20JUN96 has come off its seat. b. Turn adjusting screw (I) in to increase actual pressure reading; turn adjusting screw out to T101709 decrease pressure reading. The length from end of adjusting screw to nut must not exceed the specified length. H—Solenoid Valve I—Adjusting Screw Specification J—Nut Solenoid Valve Adjusting Screw— Pressure Change.....................................

0.069 MPa approximate per 1/4 turn 69 kPa approximate per 1/4 turn 0.69 bar approximate per 1/4 turn 10 psi approximate per 1/4 turn End of Adjusting Screw-to-Nut— Length............................................................................... 2 mm maximum 0.079 in. maximum c. Hold adjusting screw and tighten nut. Specification Solenoid Valve Adjusting Screw-to-Housing Nut—Torque.................................................... 3.0 N•m 27 lb-in. 10. Check the pressure setting again. LD30992,00002AF –19–25MAY06–4/4 9025 25 31