TM2361 (24JUN08) 9025-25-44 450DLC Excavator Operation and Tests 062608 PN=904 Tests 2. Heat hydraulic oil to specification. See Hydraulic Oil Warm-Up Procedure. (Group 9025-25.) Specification Hydraulic Oil—Temperature........................................................ 45—55°C 110—130°F 3. Run machine at specification. Specification Engine—Speed............................................................................ Fast Idle Work Mode Switch—Position...................................................... Dig Mode Power Mode Switch—Position.............................. HP (High Power) Mode Auto Idle Switch—Position....................................................................
Off Boom Mode Switch—Position............................................................... On NOTE: When a pressure reading is fluctuating, increase engine speed slightly. 4. Actuate boom down over relief. Record the pressure reading. Specification Boom Mode Relief Valve— Pressure................................................................................. 12—13 MPa 12 000—13 000 kPa 120—130 bar 1740—1885 psi 9025 25 44 Continued on next page OUT3035,0000008 –19–06JUN06–3/4