MBE 900 OPERATOR'S GUIDE filter element, twist the lower edge of the filter element to the side. See Figure 46. 9. Add new engine oil through the oil fill (see Figure 47). Figure 46 Cap with Oil Filter Element Figure 47 Oil Fill To prevent damage to the filter housing, ensure that no foreign objects get inside it. Do not wipe clean the filter housing. NOTICE: PERSONAL INJURY To avoid injury from slipping and falling, immediately clean up any spilled liquids. NOTE: Engine oil fill capacity with a standard oil pan for the six-cylinder engine is 30.6 quarts (29.0 L). For the four-cylinder engine with a standard oil pan, fill capacity is 16.7 quarts (15.8 L). 5. Replace the O-ring on the cap.
See Figure 46. 6. Install the new filter into the cap. Make sure the filter element is securely in place. 7. Screw the cap onto the oil filter housing. Tighten the cap 25 N·m (18 lb·ft). 10. Fill until the maximum fill level on the oil dipstick has been reached. Do not overfill. 8. Install the oil drain plug, using a new O-ring. Tighten the plug 65 N·m (48 lb·ft). All information subject to change without notice. (Rev. 04/08) 89 DDC-SVC-MAN-0055 04/08 Copyright © 2008 DETROIT DIESEL CORPORATION