MBE 900 ENGINE 2007 OPERATOR'S GUIDE Start the engine after the lights go out. If starting a vehicle, start the engine with foot off the foot pedal. 3. If the engine doesn't start after 30 seconds, stop. Try again after waiting two minutes. The engine should start within four 30-second attempts. NOTICE: If the warning lights stay on, or do not come on momentarily after turning on the ignition, contact the Detroit Diesel Customer Support Center at 313–592–5800. Operating the engine under these circumstances may result in engine damage. NOTICE: Do not rev the engine if the oil pressure gauge indicates no oil pressure.
To avoid engine damage, shut down the engine if no oil pressure appears within approximately ten seconds. Check to determine the cause of the problem. Electric Starter Start an engine equipped with an electric starting motor as follows: 4. Monitor the oil pressure gauge immediately after starting the engine. NOTICE: NOTE: Do not place the engine under full load until it reaches operating temperature. To prevent serious starting motor damage, do not press the starter switch again after the engine has started. Running the Engine Important: At outside temperatures below (–13°F), a coolant preheater is recommended.
While the engine is operating, monitor the battery charge indicator light, the oil pressure and avoid excessive idling. 1. Chock the tires, place the transmission in neutral, and set the parking brake. 2. With foot OFF the foot pedal, turn on the ignition switch and start the engine All information subject to change without notice. (Rev. 04/08) 29 DDC-SVC-MAN-0040 0704 Copyright © 2008 DETROIT DIESEL CORPORATION