. ATTACHMENTS, OPTIONS HANDLING AUTO-GREASING SYSTEM ATTACHMENTS, OPTIONS HANDLING AUTO-GREASING SYSTEM mode. REPLACEMENT OF GREASE CARTRIDGE WARNING 6 - 35 9. ompleting the setting, press the ESC key to leave th e setting REMARK Even if i t is desired to chan ge only one item, al ways car ry out the setting according to Steps 4 to 8. After completing th to leave the setting mode. e setting, always press the ESC key to leave the setting If the power is then turned ON, the count for th e greasin g interval wi ll s tart immediately after the ESC key is pr essed. P art of the display segment flashes to indicate that the s ystem is counting.
After setting, the set value i s retained in memor y even if t he power is turned OFF. CHECK AMOUNT OF G 1. T urn the starting switch 2. Check the display of th e pilot lamp on the machine m onitor. f th e pilot lamp is flash ing at 1-second intervals, it m eans that he grease cartridge is Replace the grease ca rtridge with a new c Ai r bleeding of pump involv es danger because of high press ure. Ask your Komatsu distributo r for air bl Be careful of the force appl ied by spring (2) instal led inside t he cover. NOTICE After replacing cartridge,make sure to reset number counter on controller.
(Refer to "TROUBLESHOOTING (PAGE 6-37)" Replace grease cartridge a ccording to procedu re descri bed below.