How to use automatic transmission Manual transmission models * Vehicle start and stop For drivers unfamiliar with vehicles with automatic transmission, the following information is particularly important. 1. Check and make sure that the gear is in neutral. 2. Press the clutch pedal all the way to start the engine. 3. Place the shift lever in "1" or reverse gear. 4. Slowly lift the clutch pedal, add oil properly, release the parking brake, and the vehicle can start. 5. When parking, depress the brake pedal to slow down the vehicle; downshift timely according to the vehicle speed. After the vehicle stops stably, apply the parking brake and place the shift lever in neutral.
Start-up The engine can only be started when the shift lever is in "P" or "n" gear. Before starting the engine, press the brake pedal. After selecting "d" or "R" gear, if the vehicle is stationary, do not let the engine run at high speed. Always apply the parking brake until you are ready to drive the vehicle away, remember that once the drive gear is selected, the automatic vehicle will move forward or backward slowly. Do not leave the vehicle stationary when the drive gear is selected and the engine is running (always select "n" if idle for a long time is required). Manual transmission model gear description "1-6" gear (forward gear): In upshift, shift from low gear to high gear in turn.
When downshifting, shift from high gear to low gear. "R" gear (reverse gear): When reversing, put into this gear. Before putting into "R" gear, make sure that the vehicle has completely stopped and the engine is in idle running state. 143