Jumper start Warning When connecting the jumper cable, firstly connect the positive terminal, and then connect the negative terminal. If the engine can’t be started up owing to the fact that the battery has discharged electricity excessively, please start up the engine by connecting the battery on another vehicle with the jumper cable. In such case, please pay attention to the following notices: ●Rated voltage of the battery must be 12V or more, and the capacity (Ah) should not be less than the battery with fault. ●Use only jumper cables with sufficiently large cross-section. ●Only use the jumper cable equipped with insulated electrode holder.
charge the battery which has been frozen - Danger of explosion! Even for the unfrozen battery, in the course of charging, battery electrolyte may also overflow and cause corrosion. The frozen battery must be replaced. ●There may be explosive hydrogen in the vicinity of the battery. The battery must stay away from sparks and open flames. jump state, the two vehicles may not touch with each other. Otherwise, once the positive poles of two batteries are connected, the circuit will be closed immediately, and thus danger may occur. ●Before carrying out any operation relating to battery, be sure to carefully read and comply with the safety instructions relating to handling of battery. Note 1.
Turn off the start/stop button. 2. Connect one end - 1- of the red power cable to the positive pole (+) of the power-receiving battery “A”. 3. Connect the other end - 2- to the positive pole (+) of the power supplying battery “B”. 238