4. Connect one end - 3 - of the black power cable to the negative pole (-) of the power-supplying battery and the other end - 4- to the engine cylinder of the power-receiving battery or a metal part which is connected with the engine cylinder. 5 Start the vehicle with the power supplying battery and let it run in idle speed, and then start the engine of the vehicle with the power-receiving battery and let run for a period of time so that the motor charges the power-receiving battery. Warnings Emergency towing The improper use of jumper cable may cause explosion of battery and serious injury. ●The engine compartment is a high risk area.
Improper maintenance could cause fatal accidents extremely easily. ●Absolutely do NOT directly connect the negative power cable to the negative pole of the power receiving battery. Otherwise, sparks will be generated the moment when the power cables are connected. The inflammable gases generated by the battery may be ignited by the sparks, thus causing explosive accidents. ●Absolutely do NOT connect the negative power cable with any part of the fuel system or the brake pipeline. Doing so may cause fire. While performing maintenance, be absolutely sure to NOT bend down and face the battery so as to protect against scalding by acids. ●Do NOT touch open flames.
Doing so may cause explosiveness, be absolutely sure to NOT bend down and face the battery so as to protect against scalding by acids. When you need to tow the vehicle, you must comply with traffic regulations. Improper towing equipment can damage the vehicle. To ensure correct towing method and protect vehicle against accidental damage, it is recommended to find a professional roadside assistance personnel to tow the vehicle. In preparation for towing, the driver and rescue personnel should observe the following precautions: ●Before towing, ensure that transmission, steering and transmission systems are in working status.
If the systems are damaged, it is necessary to load the vehicle with a plate rescue vehicle or lift the front wheels for traction. ●The driving (front) wheels of automatic transmission models vehicle must get off the ground while being towed. CAUTION ●When connecting or removing jumper cables, first fully connector disconnect a jumper cable, then the other jumper cable, never cause a short circuit. ●When removing the jumper cables, first let the fault vehicle engine idle, to prevent stalling. 239