RENR5042-02 57 Troubleshooting Section Possible Performance Effect: i02257733 CID 0002 FMI 05 Injector Cylinder 2 open circuit Engine misfires Low power Troubleshooting: SMCS Code: 1290-038 Perform the following diagnostic procedure: “Injector Solenoid Circuit - Test” Conditions Which Generate This Code: The Electronic Control Module (ECM) is attempting to operate the injector. The ECM detects an open circuit in the circuit for the injector. Results: OK STOP. System Response: The ECM will log the diagnostic code. The ECM will continue to attempt to operate the injector after the code has been logged. i02214566 CID 0001 FMI 11 Injector Cylinder #1 fault SMCS Code:
1290-038 Possible Performance Effect: Engine misfires Conditions Which Generate This Code: Low power The Electronic Control Module (ECM) is attempting to operate the injector. The ECM detects an open circuit or a short circuit in the circuit for the injector. Troubleshooting: Perform the following diagnostic procedure: “Injector Solenoid Circuit - Test” If the cause of the diagnostic code is a problem in the common wire, two cylinders will be affected because of the shared common wire for the injectors. Results: System Response: OK STOP. The ECM will log the diagnostic code. The ECM will continue to attempt to operate the injector after the code has been logged.
i02257748 CID 0002 FMI 06 Injector Cylinder 2 short The injector may not operate while the condition exists. SMCS Code: 1290-038 Possible Performance Effect: Conditions Which Generate This Code: Engine misfires The Electronic Control Module (ECM) is attempting to operate the injector. The ECM detects a short circuit in the circuit for the injector. Low power Perform the following diagnostic procedure: “Injector Solenoid Circuit - Test” System Response: Results: The ECM will log the diagnostic code. The ECM will continue to attempt to operate the injector after the code has been logged. OK STOP. Possible Performance Effect: Engine misfires Low power