58 RENR5042-02 Troubleshooting Section Troubleshooting: i02257759 CID 0003 FMI 05 Injector Cylinder 3 open circuit Perform the following diagnostic procedure: “Injector Solenoid Circuit - Test” Results: SMCS Code: 1290-038 OK STOP. Conditions Which Generate This Code: i02214575 CID 0002 FMI 11 Injector Cylinder #2 fault The Electronic Control Module (ECM) is attempting to operate the injector. The ECM detects an open circuit in the circuit for the injector. System Response: SMCS Code: 1290-038 The ECM will log the diagnostic code. The ECM will continue to attempt to operate the injector after the code has been logged. Conditions Which Generate This Code:
The Electronic Control Module (ECM) is attempting to operate the injector. The ECM detects an open circuit or a short circuit in the circuit for the injector. Possible Performance Effect: Engine misfires If the cause of the diagnostic code is a problem in the common wire, two cylinders will be affected because of the shared common wire for the injectors. Low power Troubleshooting: System Response: Perform the following diagnostic procedure: “Injector Solenoid Circuit - Test” The ECM will log the diagnostic code. The ECM will continue to attempt to operate the injector after the code has been logged. Results: The injector may not operate while the condition exists. OK STOP.
i02257773 CID 0003 FMI 06 Injector Cylinder 3 short Possible Performance Effect: Engine misfires Low power SMCS Code: 1290-038 Perform the following diagnostic procedure: “Injector Solenoid Circuit - Test” Conditions Which Generate This Code: The Electronic Control Module (ECM) is attempting to operate the injector. The ECM detects a short circuit in the circuit for the injector. Results: OK STOP. System Response: The ECM will log the diagnostic code. The ECM will continue to attempt to operate the injector after the code has been logged. Possible Performance Effect: Engine misfires Low power