UPPERSTRUCTURE / Cab Procedure to Install Cab Glass Procedures to Install Right-Hand Glass, Rear Left-Hand Glass, Lower Door Glass and Rear Glass 1. Cut off the residual adhesive from cab side by 1 to 2 mm deep all around by using a cutter knife or similar. Right-Hand Glass NOTE: Do not damage the cab paint. 2. Clean the cutting edge of adhesive at cab side by using white spirit. IMPORTANT: Primer should be shaken for about 1 minute and mix thoroughly before opening the cap. After opening Primer, apply Primer as quickly as possible and replace the cap immediately after using. After opening Primer, all the contents should be used within 180 days (or 2 hours with the cap off). 3.
Apply Primer for paint (Sika Aktivator DM-1) to the cutting edge of adhesive at cab side by using a brush. Wait for about 15 minutes in order to let it dry by itself. W1JB-02-01-009 Rear Glass W1JB-02-01-010 Rear Left-Hand Glass Lower Glass of Door Cab Cut Knife Cut off Adhesive by 1 to 2 mm Deep W1SE-02-01-036 NOTE: The painting primer should be applied evenly in order to leave no blemishes. Cab Apply Primer 24 Cutting Edge of Adhesive at Cab Side W1SE-02-01-038 W2-1-15