UPPERSTRUCTURE / Cab 4. Clean the mating edge of new glass by using clean rag and ethylalcohol. IMPORTANT: Primer Sika Primer Z06G+P should be shaken for about 1 minute and mix thoroughly before opening the cap. After opening Primer, apply Primer as quickly as possible and replace the cap immediately after using. After opening Primer, all the contents should be used within 180 days (or 2 hours with the cap off). 5. Apply Primer for glass (Sika Primer Z06G+P) to the cutting edge of adhesive at cab side by using a brush. Wait for about 15 minutes in order to let it dry by itself. (As for the position to apply Primer, refer to W2-1-15.) 6.
Install the spacer with facing to the glass surface by using the instant adhesive. (As for the positions to install spacers A, B and C dam rubber, refer to W2-1-18.) 7. Cut off the nozzle of adhesive cartridge (Sika Tack-Drive) into V-shaped by using a knife. (Refer to W2-1-18.) 8. Remove the seal of cartridge. Install the V-shaped nozzle. 9. Install the cartridge to the manual coking gun. 10. Apply adhesive to the adhesive position at cab side so that the bead triangle may be even. (As for the position to apply adhesive refer to W2-1-18.) 11. Suck, raise the glass by using sucker lifter 4355282 (refer to W2-1-18), and adhere it to the cab within 5 minutes. NOTE:
Install the glass while aligning the spacer position on the glass. Remove all adhesive except the mounting surface, before solidifying by using white spirit. 12. Secure the glass by using the gummed tape until the adhesive becomes solid in order to prevent them from being mispositioned or coming off. NOTE: Time for adhesive (Sika Tack-Drive) to become solid: 8 hours (just for reference) W2-1-16