Components resistance, it could be difficult to move the remote control lever or throttle grip, which could result in an accident. [EWM00032] To decrease resistance, turn the adjuster counterclockwise. 1. Fully open 2. Fully closed EMU26221 Choke switch To activate the choke system, press in the main switch while the key is turned to the ” (on) or “ ” (start) position. The choke system will then supply the rich fuel mixture required to start the engine. When the key is released, the choke will switch off automatically. When constant speed is desired, tighten the adjuster to maintain the desired throttle set- ting.
EMU25993 Engine shut-off cord (lanyard) and clip The clip must be attached to the engine shut- off switch for the engine to run. The cord should be attached to a secure place on the operator’s clothing, or arm or leg. Should the operator fall overboard or leave the helm, the cord will pull out the clip, stopping ignition to the engine. This will prevent the boat from running away under power. WARNING! At- tach the engine shut-off cord to a secure place on your clothing, or your arm or leg while operating. Do not attach the cord to clothing that could tear loose. Do not route the cord where it could become en- tangled, preventing it from functioning.
Avoid accidentally pulling the cord dur- ing normal operation. Loss of engine power means the loss of most steering control. Also, without engine power, the boat could slow rapidly. This could cause people and objects in the boat to be ZMU03160 EMU25973 Throttle friction adjuster A friction device provides adjustable resis- tance to movement of the throttle grip or the remote control lever, and can be set accord- ing to operator preference. To increase resistance, turn the adjuster clockwise. WARNING! Do not overtighten the friction adjuster. If there is too much 21