Components thrown forward. [EWM00122] (start) With the main switch in the “ ” (start) po- sition, the starter motor turns to start the en- gine. When the key is released, it returns automatically to the “ ” (on) position. 1. Cord 2. Clip 3. Engine shut-off switch EMU26011 Choke knob for pull type To supply the engine with the rich fuel mix- ture required to start, pull out this knob. EMU32052 Power trim and tilt switch on remote control The power trim and tilt system adjusts the outboard motor angle in relation to the tran- som. Pressing the switch “ ” (up) trims the outboard motor up, and then tilts it up. Press- ing the switch “ ” (down) tilts the outboard motor down and trims it down.
When the switch is released, the outboard motor will stop in its current position. For instructions on using the power trim and tilt switch, see pages 47 and 49. ZMU03903 EMU26090 Main switch The main switch controls the ignition system; its operation is described below. (off) With the main switch in the “ ” (off) posi- tion, the electrical circuits are off, and the key can be removed. (on) With the main switch in the “ ” (on) posi- tion, the electrical circuits are on, and the key cannot be removed. 22