12.OPERATION Armrest angle adjustment When armrest is lifted, locking is applied at each 8° setting. When it is fully sprung up, locking is released. Adjustable armrest angle: 32° (in 4 steps) REMARK If the back seat is tilted back and forth without raising armrest it will spring up automatically. Fore-and-aft adjustment of whole seat After lever is pulled up and the seat is set to the desired position, release the lever. In this case the operator's seat, left and right levers and safety lock lever will slide together. Adjustable fore-and-aft movement: 120 mm (4.7 in). ADJUSTING OPERATOR'S SEAT (Seat with suspension) Fore-and-aft adjustment of seat Pull lever up.
After the seat is set to the desired position, release the lever. Adjustable distance: 100 mm (3.9 in) in 10 steps. Adjustment of reclining seat NOTICE The amount of reclining for the seat is greatest when the seat is moved forward, and becomes smaller as the seat is moved to the rear. For this reason, when moving the seat to the rear, set the seat back to the upright position. Pull lever up. After the seat back is set to the optimum position for easy operation, release the lever. Sit with your back against the seat back when adjusting. If your back is not touching the seat back, the seat back may suddenly move forward. Adjusting seat tilt 1.
Forward tilt Push lever down and adjust the angle at the front of the seat. (4 stages) 1. To raise the angle at the front of the seat, keep the lever pushed down and apply your weight to the rear of the seat. 2. To lower the angle at the front of the seat, keep the lever pushed down and apply your weight to the front of the seat. PC130/150LGP-6K ENG 2-44 WARNING • Adjust the seat position at the beginning of each shift or when operators change. • Adjust the seat so that the travel pedal can be depressed all the way with the operator's back against the backrest. WARNING