12.OPERATION 2. Rear tilt Pull lever up and adjust the angle at the rear of the seat. (4 stages) 1. To raise the angle at the rear of the seat, keep the lever pulled up and stand up slightly to remove your weight from the seat. 2. To lower the angle at the rear of the seat, keep the lever pulled up and apply your weight to the rear of the seat. Amount of tilt: Up 13°, down 13° 3. Seat height adjustment By a combination of steps 1 and 2, the seat can be moved up and down. After the desired height is set by forward/backward tilting, bring the seat to the horizontal position by reverse-tilting and fix it. Adjustable height:
60 mm (2.4 in) Adjusting armrest angle Armrest can be made to spring up by hand to an angle of approx. 90°. In addition, by turning the bottom of the armrest by hand it is pos- sible to make fine vertical adjustments of the armrest angle. Armrest adjustment angle: 25° REMARK If the back seat is tilted back and forth without raising armrest , it will spring up automatically. Fore-and-af adjustment of whole seat After lever is pulled up and the seat is set to the desired position, release the lever. In this case the operator's seat, left and right levers and safety lock lever will slide together. Adjustable fore-and-aft movement: 120 mm (4.7 in).
Suspension adjustment When knob is turned clockwise, the suspension becomes harder and when turned counterclockwise, softer. Adjust the dial so that the sus- pension best matching the operator's weight is selected. REMARK To obtain the optimum adjustment, turn the knob so that the indicator of the weight display (kg) in the transparent portion of knob is the same as the operator's weight. PC130/150LGP-6K ENG 2-45