2.2 General precautions Safety Working on loose ground z Do not drive the machine too close to edges of hills, over- hangs, and deep ditches. z If the soil starts to sag at these locations, the machine may tip over, fall down, or roll over, thus injuring you severely. z Take into account that the soil is wet and soft after heavy rainfall, or very loose after blasting. Do not go close to high-voltage cables Do not travel or operate the machine near electric cables. There is a hazard of electric shock, which may cause serious injury or property damage. On jobsites where the machine may go close to electric cables, always do as follows.
z Before starting work near electric cables, inform the local power company of the work to be performed, and ask them to take the necessary action. GK032047 z Even going close to high-voltage cables can cause electric shock, which may cause serious burns or even death. Always maintain a safe distance (see the table on the right) between the machine and the electric cable. Check with the local power company about safe operating procedure before starting operations. z To prepare for any possible emergencies, wear rubber shoes and gloves. Lay a rubber sheet on top of the seat, and be careful not to touch the chassis with any exposed part of your body.
z Use a signalman to give warning if the machine approaches too close to the electric cables. z When carrying out operations near high voltage cables, do not let anyone come close to the machine. z If the machine should come too close or touch the electric cable, to prevent electric shock, the operator should not leave the operator's compartment until it has been confirmed that the electricity has been shut off. Also, do not let anyone come close to the machine. Ensure good visibility Check for any persons or obstacles in the area around the machine and check the conditions of the jobsite to ensure that operations and travel can be carried out safely. Always do as fol- lows.
z Position a signalman if there are areas at the rear of the machine where the visibility is not good. 2-14 WA150-5H – VEAM934100 Nominal Voltage Safety Distance up to 1000 V 1 m over 1 kV up to 110 kV 3 m over 110 kV up to 220 kV 4 m over 220 kV up to 380 kV 5 m with unknown nominal voltage 5 m