NOTE: The differential lock is intended for use where minimum traction is available. Steering effort will increase with the front differen- tial lock engaged. Maneuverability and handling characteristics will differ with the differential lock engaged. ! WARNING Make sure the steering wheel is locked securely in place before moving the vehicle, or steering wheel movement could occur causing loss of control. Headlight Switch Foot Brake The foot brake is the only service brake, and it should be applied whenever brak- ing is needed. Apply the brake by pressing the brake pedal down.
Steering Wheel Tilt Latch Pull on the lever located on the steering column and move the steering wheel to the desired position; then release the lever and make sure the steering wheel locks securely. PR883A With the ignition switch in the LIGHTS position, use the headlight switch to select light bar, light bar with low beam, or light bar with high beam. Reverse Override Switch This vehicle is equipped with a reverse speed limiter system. When additional RPM is needed in reverse, depress and hold the override switch located on the center console. NOTE: The vehicle must be in 4WD to activate the reverse override. WT002A ! WARNING !
WARNING Make sure the steering wheel is locked securely in place before moving the vehicle, or steering wheel movement could occur causing loss of control. Never activate the override switch while the throttle is open as a loss of control could result. Use caution when using the override switch as reverse speed can greatly increase. Accelerator Pedal Press down on the pedal to increase engine RPM and vehicle speed; release the pedal to decrease engine RPM and vehicle speed. NOTE: This vehicle is equipped with an RPM limiter that retards ignition timing when maximum RPM is approached. When the RPM limiter is activated, it could be mis- interpreted as a high-speed misfire. PR880A 24