MAINTENANCE 7. Fill a new oil filter with engine oil. Then, apply engine oil or a thin coat of grease to the seal. 8. To install filter, bring its seal surface into contact with sealing surface of filter base and then tighten the filter Ѕ to ѕ turn by hand. Be careful not to tighten it up excessively. Be sure to use a genuine filter. 9. After replacing the filter, pour in the specified quantity of engine oil at oil filler (2). 10. After refilling with oil, start the engine and idle it for a while. Inspect for oil leaks at the filter and drain plug. Then stop the engine and check the oil level. Wait for five minutes before checking. 11. Close the engine hoods.
Diluted oil can cause severe damage to the engine. Check the condition of the used oil. Thin, black oil indicates fuel dilution. Milky discoloration indicates coolant dilution. 24.6.2 CHECK FOR LOOSE WHEEL HUB BOLTS, TIGHTEN If wheel hub bolts (1) are loose, tire wear will be increased and accidents may be caused. If any hub bolts are loose, tighten them to the specified tightening torque. Bolt torque . . . . . . . . . . 927 ± 103 N If any wheel bolt is broken, replace all bolts for that wheel. Always rotate in the direction of tightening when checking for loose bolts. 3-49 WA320-3MC