MAINTENANCE 24.6.6 CORROSION RESISTOR WARNING Do not remove the radiator cap from a hot engine. Hot steam will cause serious personal injury. Wait until the coolant temperature is below 50 e pressure cap. Remove the coolant system pressure cap and close the shutoff valve before removing the corrosion resistor. Failure to do so can result in personal injury from heated coolant spray. Filter wrench . . . . . . . . . . . . . . . . . . . . . . . . . . . 09019-08035 1. Remove and discard the corrosion resistor. Clean the gasket surface. 2. Apply a light film of lubricating oil to the gasket sealing surface before installing the corrosion resistor.
REMARKS Mechanical over tightening may distort the threads or damage the filter head. 3. Install the new cartridge according to the manufacturers recommendations. 4. Open the shutoff valve and install the coolant system pressure cap. NOTE Failure to open the shutoff valve can result in severe engine damage. 5. Run the engine and check for leaks around the cartridge. 3-52 WA320-3MC