DOWNLOAD OF INFORMATION DISPLAY OF FAULT CODES Payload information and fault codes recorded should be downloaded to a personal computer on a regular basis. The software required is available under part number AK4635. Detailed instructions for installing the software and downloading the data is provided with AK4635 PLM ΙΙ download software. 1. Press and hold the MODE switch until "Cd:dP" is displayed. 2. Press the MODE switch once. The display will show: 3. Press the MODE switch once. The display will show: Data All Clear This function will erase all of the cycle data, engine ON/OFF data, and fault/warning data. Total payload and the overall number of cycles will not be cleared. 4.
Press the TOTAL/SFT switch. If there are no faults or warnings, the display will show for 6 seconds. IMPORTANT - Before clearing the data, download the data to a personal computer. If there are current faults or warn- ings, the codes will be displayed in order of their priority, the highest priority first. Each code will flash for 6 seconds. To begin, the shift lever should be in the “N” position, the brake lock set, the hoist control lever should be in the “FLOAT” position and the body in the down posi- tion. 5. After the current codes have been displayed, past history codes that have been reset will be dis- played. Each code will flash for 3 seconds. 1.
Press and hold the MODE switch until "Cd:dP" is displayed. If there are no history codes or after all history codes have been shown , the display will show for 3 seconds: 2. Press the MODE switch once. The display will show: The system will then proceed to the following displays: Refer to Page 22 for details. 3. Press and hold the CAL/CLR switch until "A.CLE" is flashing. Condition of the shift selector on mechanical trucks or brake lock on electric trucks. 4. Press the CAL/CLR switch again and the memory will be cleared. The meter will then return to normal operation. The panel will display: “ C1:XX ” for 3 seconds, then indicate: This does not clear the Operator Load Counter.
C1:oo ” Shift selector is in "N". Mechanical trucks ” Shift selector is not in "N’. Electric trucks C1:oo ” Brake lock is on. ” Brake lock is off. Condition of the Body Up Switch signal. The panel will display: “ C2:XX ” for 3 seconds, then indicate: C2:oo ” Body up switch is in up position. ” Body up switch is in down position. M20007.1 03/02 Payload Meter II M20-21