11. EXPLANATION OF COMPONENTS 9. STEREO INDICATOR (ST) This lamp lights up when a stereo broadcasting is picked up when receiving an FM broadcasting station. 11.12.2 METHOD OF OPERATION METHOD OF SETTING PRESET BUTTONS 1. Press power switch 1 and display the frequency on display 7 . 2. Turn the tuning button (manual, auto) to adjust to the desired frequency. 3. Select a preset button to use for recording the frequency setting, and keep that button pressed for at least 1.5 seconds. The sound will disappear, but when the setting is recorded, the sound will appear and the preset number will appear on display 7 to show that the station has been preset.
After completion of presetting, press preset button 6 , and release it within approx. 1.5 seconds. The setting will change to the frequency of the broadcasting station recorded for that button. One AM station and one FM station can be recorded for each preset button. AM090040 AM090060 MANUAL TUNING Press tuning button 5 and set to the desired frequency. Each time the button is pressed, the frequency will move up or down in steps of 9 kHz (AM) or 0.1 MHz (FM). , button: Move to a higher frequency station . button: Move to a lower frequency station If the frequency reaches the top or bottom limit, it will automati- cally change as follows:
top limit bottom limit, or bottom limit top limit AUTOMATIC TUNING Keep tuning button 5 pressed for at least 0.5 seconds. When a broadcasting station is picked up, it will automatically stop. To search for the next station, press tuning button 5 again for at least 0.5 seconds. , button: Move to a higher frequency station . button: Move to a lower frequency station If tuning button 5 is pressed during auto tuning, the auto tuning will be canceled and the frequency at the point where it is canceled will be picked up. 2-35